top of page

How to Read a Supplement Certificate of Analysis

Nov 12
3 min read

Your first production run is complete, and your manufacturer sends a certificate of analysis. The report says “Pass,” but what did the lab measure? Which lot was sampled? What criteria did the results have

to meet?

Quality Control filling out a COA
Quality Control filling out a COA

A certificate of analysis, or COA, is easier to interpret when you read it alongside the product specification. The specification defines the criteria the material or product needs to meet. The COA reports the results for the tests it lists. Together, they help your team understand what was verified before a batch was released.


Start with the lot number

Check that the COA identifies the product or ingredient you’re reviewing and that its lot number matches the shipment or batch in question. If a delivery includes two finished-product lots, make sure you have the corresponding documentation for both. Two bottles can share the same label and formula while coming from different production runs.


Also check what was sampled. A raw material COA describes a specific ingredient lot. A finished-product COA describes the capsule or powder batch identified on the report. For example, a supplier’s COA might report the strength of a botanical extract before blending. A finished-product test can help assess how much of the measured compound is present in the final serving, if that test is included.


Read the result and the specification together

A COA may include the test name, method, acceptance criteria, and result. Read across the row so you can see how the result was evaluated. Here’s a hypothetical example for a powder blend.

Test

Acceptance criterion

Result

Moisture

Maximum 5.0%

3.2%

Lead

Maximum 0.20 mg/kg

0.08 mg/kg

These numbers illustrate how to read a COA. The appropriate criteria depend on the product and its intended use.


Units deserve a close look. A lab may report an elemental impurity in milligrams per kilogram, while your team evaluates the amount per serving. In the example above, 0.08 mg/kg corresponds to 2.4 micrograms in a 30-gram serving. That conversion lets your team compare the result with a criterion expressed per serving.


Ask what “Pass” or “Not Detected” means

A “Pass” result tells you the sample met the stated criterion. If the report only shows “Pass,” ask whether you can review the underlying result and acceptance criterion.


A “Not Detected” result means the lab did not detect the substance under the conditions of the test. If your team needs to evaluate a specific threshold, ask for the lab’s reporting limit and check that it’s low enough to support that comparison. If a test you expected is missing, ask whether it appears on a separate lab report, was performed on an incoming ingredient, or falls outside the agreed testing plan. That distinction matters when a retailer asks for evidence tied to the finished lot.


Agree on the COA before production begins

The best time to discuss what you’ll receive with each batch is before you approve the production run. Ask your manufacturer to walk through a sample COA and clarify:

  • Which tests apply to the finished product? Discuss whether your formula calls for ingredient content, microbiological, elemental impurity, or other testing.

  • What criteria will the results be compared against? Confirm the units and whether limits are expressed by weight, per capsule, or per serving.

  • Who performs the tests? Ask which checks are done in-house and which are sent to an external lab.

  • What records come with the shipment? Confirm whether you’ll receive a batch COA, supporting lab reports, or both.


Planning a capsule or powder supplement? Share your formula, serving size, and any retailer testing requirements with Strata Biotech Labs so we can discuss what your batch documentation needs to show.

Comments


© 2025 by Strata Biotechnology Labs. Powered and secured by DRC

bottom of page